Manual of AT OnLine!
anaerobicthreshold.org


Step 1. - Select Source

Decide if the data will be typed online into the Web Form or the data will be load from the text file in certain form [see bellow]




Figure: Selecting source


Select Your country. The pop-up list includes all FIPS 10-4 countries listed in alphabetical order, and the most common visitors are listed in front of the list. If you type the first letter into the rolled list you move to the first country starting with this letter.

To continue you have to press "Accept" button, with this you agree with Terms of Use and Evaluation.

Step 2a. - Using WebForms - Preparation

Type firstly the correction factors BTPS and STPD. If you do not known them than you use "Calculator" see Step 3




Figure: Preparation of WebForms


Select the type of exercise test you are going to perform. You have to select from the 6 possibilities. Select best choice according to your measuring devices.




Figure: Type of Exercise Test


Type duration of measuring intervals. Use seconds for expressing the duration i.e. if you measure in one minute intervals, than type 60.

Type the Total Number of Measured Intervals according to previously typed duration. So if you expect to measure 6 minutes in half minute intervals, than type 12.

Insert data about tested person (Age, Weight, Height and Sex). Use ISO metric units.

The data are checked to be correct, if an alert appears, than you have to correct data to proceed further.

Step 2b. - Using Data File - Preparation

Type firstly the correction factors BTPS and STPD. If you do not known them than you use "Calculator" see Step 3




Figure: Preparation of Data File


Select the name and location of Your data file, with the help of "Browse" button. It is expected that data are in the format where each line represents one complete record. The first line could be the header - the name of the columns. It is required to have complete data records. The first column coud be time in the form [mm:ss] or [mm.(mm/10)].

Decide about the names of colums. Either the first line of file includes the required description in the form parameter1 tab parameter2 ... and then check the select biox of the first choice or type the parameter name in the input box; use only allowed names. If the first option is checked than it is typed values omitted.

Insert data about tested person (Age, Weight, Height and Sex). Use ISO metric units.

The data are checked to be correct, if an alert appears, than you have to correct data to proceed further.

Step 3. - Calculating BTPS and STPD

Type the temperature and the pressure in the input boxes. You can use any unit you like and press button "Calculate".




Figure: Calculate BTPS and STPD


Step 4a. - Using WebForms - Typing

Type the measured data in prepared input boxes.




Figure: Preparation of WebForms


Press "Determine AT" to start calculation.

Press "Go to back and correct inputs" if you want to make changes.

Step 4b. - Using Data File - Check

The measured data are displayed.




Figure: Check of data from the file


Press "Determine AT" to start calculation.

Press "Go to back and correct inputs" if you want to make changes.

Step 5. - Result

The evaluation of measured data is displayed.




Figure: Result of evaluation


You can type here the name of tested person, laboratory, physician and notes to input boxes prior print. You can print it in Internet Explorer, but then the formatting is deformed or you can create the PDF Report of the Examination.

Note: You have to install at least the Adobe Reader to see reports. It could happen an error during the creation of report in Internet Explorer. Use then "Refresh" button of Internet Explorer or better use Mozilla FireFox as the browser instead.

Press "Create PDF Report" to make it. You can insert free lines if you want to use print the result to the header paper of your workplace.

Press "Start next evaluation" if you want to make new evaluation.

 
anerobicthreshold.org 2007